Once you have set your master transmitter you can set the remote Speedlite to manual mode and select the power setting required without touching the Master unit. At just £150 it is a fraction of the cost of a 580 Speedlite and frees up your flash for off camera use. It doesn’t emit a pre flash that causes blinks in subjects.ģ. It is a fraction of the weight of a Speedlite and when working hand held this makes a big difference.Ģ. The ST-E2 commander has three distinct advantages over the 580 ‘master’ option.ġ. The 430 and 430EX11 Speedlites do not have a ‘master’ enabled function. If you are a Canon shooter you can set either a 580EX or a 580EX11 Speedlite to be a master controller or use a dedicated ST-E2 commander. You will then need to set the flash to Manual mode and set the desired power level locally on the flash head. To enable this set up to work you need to connect each remote SB-800 or SB-900 flash unit to a PW unit using the sync socket on the flash using a PC sync to 1/8” mono jack lead. If you don’t have either or you want to work at greater distances than the infra red trigger system will allow then you need to use a radio trigger system like a pair of Pocket Wizard Plus 2s. You get to be able to set 3 groups of flashes remotely. This means you can change the power of a remote flash with just 1 press of a button.ģ. The functions are readily available without the need to navigate through menus. There is no pre flash to cause blinks in your subject.Ģ. These cost about £250 and do the same function as the built in flash commander but have three added advantages:ġ. If you don’t have a pop up flash and want to remotely control your Speedlights you will have to invest in an another Speedlight to act as a master unit or buy yourself an SU-800 commander. This is great if you have flashguns high up on stands and avoids the need to grapple with each unit in turn. Then set independent power values for A and B as required. You will want to set the ‘built in flash’ to off by asigning it ‘–‘ using the mode selector. You just have to navigate to the ‘pencil’ menu on your camera, select ‘bracketing and flash’, then ‘flash control for built in flash’, ‘commander mode’ and then assign a channel and set each group A, or B, to Manual. If you are a Nikon shooter and are fortunate enough to have a camera with a pop up flash you can use the built in commander mode to set the manual firing of all your remote Speedlight without the need for any additional equipment. (Speedlite is the Canon spelling of the word and Speedlight is the Nikon branding). If you are familiar with their operation you will be ready to go with Speedlights. Speedlights set to manual mode perform exactly like other manual flash units you might find in a studio or powered by a battery pack on location. Manual operation of Speedlights is desirable when you require a series of repeat shots of identical brightness, when shooting event pictures for instance. If you want to use a non TTL radio remote set up to trigger your Speedlights or you want to know how to use them in manual mode, follow this guide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |